Smart PowerCharge - DJI Inspire 1, Matrice 600, and Matrice 100 Multi-Battery Smart Charging Station (SPCM100)
Notify me when back in stock
The Smart PowerCharge multi charger for DJI Inspire 1, Matrice 600, and Matrice 100 SPCM100 is a commercial grade QUAD Charging Station designed and built exclusively for the DJI SMART BATTERY (LiPo) that is used in your INSPIRE 1. This system is MICRO-PROCESSOR controlled with built in Over-Voltage protection, Over-Loading Protection and Temperature Control on power supply input. The Short-Circuit protection on power supply input insures safe operation while charging the batteries. The SPCM100 also monitors the voltage and temperature to each battery insuring that each battery is charged safely eliminating damage and LIPO safety concerns.
The Smart PowerCharge for Inspire 1, Matrice 600, and Matrice 100 is capable of charging or deep cycling 4 DJI Smart Batteries simultaneously, up to two tablets (or any USB device), and two remote controllers (via two 26v charging ports on the end of device), all at the same time. You can even DEEP CYCLE some batteries while charging others. When you put a SLOT in DEEP CYCLE MODE, it LOCKS discharge at low voltage down to 8%. After the battery reaches 8%, the system will automatically charge the battery to full capacity. The SPC4500 Charging Station is capable of simultaneously charging the TB47, TB48, TB47S, TB48S, TB47D and TB48D. Set em in, turn it ON and forget it! A must have for serious drone users.
If you want to use the SmartPowerCharge system on the go, it can be used with a pure sine wave inverter with 800W RMS. Or an inverter generator such as a Honda EU 10i.
Max power pulled by charger is 550W.
Smart powerchargerBy: Peter on 6 December 2016Great charger for Inspire 1,but manual supplied is outdated and does not mention the procedure for storage charge. I can charge 4 x TB 47 battery's in 90 minutes, and 4 x TB 48s in 105 minutes.
Great valueBy: Alan on 23 January 2016Very convenient charger being able to charge all equipment at once.
Must Have Accessory for Inspire 1 Flyers with MultBy: Martin on 13 October 2015As a regular Inspire 1 flyer, with a collection of smart batteries, keeping them serviced and charged is critical. This unit provides safe and secure charging for up to 4 at the same time, plus remotes with voltage readout, and deep discharge cycling when needed. It is quite large and heavy, and well built. Highly recommended. The charge time may be similar to the single unit supplied with the Inspire, but batch charging means I can prepare all batteries overnight, ready for a full days flying.